The main differences between gear oil pumps and roots oil pumps are as follows: 1. The difference between the internal gear of the gear oil pump and the Roots oil pump is the external gear pump and the external rotor pump. Gear oil pumps ge...

(1) Check the temperature rise of the pump and motor frequently. The temperature rise of the bearing should not be greater than 150C, and the limit temperature should not be greater than 250C. (2) Pay attention to the change of the oil stor...

Safety precautions for high temperature gear pumps units: 1. The quality of the high-temperature gear pump installation has a very important impact on the smooth operation and service life of the pump, so the installation work must be carri...

Gear pumps are classified into internal gearing and external gearing according to the meshing classification. General KCB, YCB, 2CY and other models are external gear pumps. Internal gear pumps are NYP internal gear pumps. So what are its a...

Corrosion resistance of magnetic pump The magnetic pump produced by saiken pump industry, the magnetic pump using fluoroplastics has flame resistance and excellent heat resistance; has excellent chemical resistance and solvent resistance; e...

Installation of magnetic pump 1. Make a concrete foundation according to the installation size of the pump; 2. Before installation, check the pump and motor, all parts should be intact, and there should be no debris in the pump; 3 Put the u...

Magnetic drive pumps and canned motor pumps are mainly used in hazardous media, where leakage is not allowed. Their impellers and performance are the same as centrifugal pumps, but the applications are affected by the cleanliness and temper...

1. The advantages of magnetic pump 1. Since the drive shaft does not need to penetrate the pump casing, but uses the magnetic field to transmit torque through the air gap and the thin wall of the isolation sleeve to drive the inner rotor, s...