+8617731766260/18233754501 
fan@saikenpumps.com
The stainless steel gear pump will inevitably encounter the gear stuck when it enters the dirty things suddenly. At this time, it is necessary to disassemble the KCB stainless steel gear pump. Next, I will tell you the correct disassembly steps of the SS KCB stainless steel gear pump. You can easily solve the failure by following the steps.
First cut off the power supply of the KCB stainless steel gear pump motor. After the KCB SS gear oil pumps stops, close the control valve on the discharge pipe. Disassemble the coupling on the shaft end of the KCB stainless steel gear pump. If it is found that the fit is too tight, you can gently tap it out with a copper rod or use a special remover to remove it. It is not allowed to strike hard with a hammer. After removing the coupling, remove the gland of the shaft end of the KCB stainless steel gear pump, and then remove the mechanical seal or flexible graphite ring. Remove the front cover and back cover of the KCB stainless steel gear pump, and then remove the gasket. Remove the bearing seat of the KCB stainless steel gear pump, and then take out the main and driven shaft gears. The KCB stainless steel gear pump has been disassembled.
+8617731766260/18233754501
+86-317-8227664
+8618233754501